Over 20 Years Experience In Forming Tube & Pipe
Tube Bending has a comprehensive list of die sets to mandrel bend tube and nominal
Pipe from 9.5mm to 101.6mm outside diameter. If we don’t have the exact die set
needed, we can use our in-house machining capabilities to produce the required tooling
in a timely fashion.
Below is our tooling chart. We are constantly adding to our tooling dies. If the size you
need is not on our chart, please contact us.
Pipe from 9.5mm to 101.6mm outside diameter. If we don’t have the exact die set
needed, we can use our in-
Below is our tooling chart. We are constantly adding to our tooling dies. If the size you
need is not on our chart, please contact us.
All measurements to centre line unless otherwise stated.
All measurements in millimetres (mm) unless otherwise stated.
Click on the link below to jump to the relevant tooling chart
Tube Bending Ltd.
50 Cryers Rd., East Tamaki, Auckland, New Zealand
Phone: 64 09 274 4906
Fax: 64 09 274 4273
E-
* Diameter may vary slightly with different batches of tube.
ALUMINIUM PROFILE: We can bend aluminium profile, however tooling has to be made to fit the actual profile.
